Publicité
2. Pull the handle on the filter underneath
the hood and slightly tilt the front of the
filter down.
1
3. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
4. To mount the filters back follow the first
two steps in reverse order.
Repeat the steps for all filters if applicable.
6.3 Replacing the charcoal filter -
optional
Depending on type, filter can be or
cannot be regenerated. Refer to the
leaflet provided with the filter.
To replace the filter:
7. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in this
chapter.
2. press the tab (1) and slightly tilt the front
of the filter. There are two charcoal filters.
One situated underneath (A) and the
other at the front side (B) of the
appliance.
2
A.
2
B.
3. To install a filter, perform the same steps
in reverse order.
6.4 Replacing the lamp
This appliance is supplied with a LED lamp
and separate control gear (LED driver).
These parts can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
67
1
1
1
Publicité
