Publicité
Function
10
Lamp
5. DAILY USE
5.1 Using the hood
Check the recommended speed according to
the table below.
While heating up food, cooking with covered
pots.
While cooking with covered pots on multiple
cooking zones or burners, gentle frying.
While boiling and frying big quantities of food
without a lid, cooking on multiple cooking
zones or burners.
While boiling and frying big quantities of food
/
without a lid, big humidity.
Refreshes the air in kitchen after cooking at a
very low noise level. It can be activated and
de-activated by touching the symbol. The
function turns off automatically after 60 mi‐
nutes. Use after cooking only.
It is recommended to leave the hood
operating for approximately 15 minutes
before and after cooking.
Activating the appliance
The control Panel is a sensor field. To
operate the hood touch the symbol
exactly in the middle for at least 1
second.
To operate the hood:
1. Turn on the appliance by pressing the
symbol.
You can now activate the functions.
2. To activate the function touch the symbol.
Description
Turns the lights on and off. Changes the light intensity.
Deactivating the appliance
To turn off the appliance press the
again.
Lighting
The hood lighting works independently to
other hood functions.
Activating and deactivating the lighting
To illuminate the cooking surface touch the
symbol. Touch the symbol again to
change the light intensity in the following
order: Maximum, Medium, Low, Off.
To switch off the lights, touch and hold the
symbol for 3 seconds.
5.2 Hob2Hood®
It is a function that connects the hob to a
hood. Both the hob and the hood are
equipped with an infrared signal
communicator. The fan speed is determined
based on the mode setting and the
temperature of the hottest cookware on the
hob. Alternatively, you can manually control
the fan using the hob. This function can be
activated from the hob's control panel.
For more information how to use the
function, refer to the hob user manual.
5.3 Filter notification
The filter alarm serves as a reminder to clean
the grease filter and either replace or clean
the charcoal filter, depending on its type. The
symbol blinks regularly for 30 seconds if
the grease filter must be cleaned. The
65
symbol
Publicité
