symbol blinks twice per every second for 30
seconds if the charcoal filter must be
replaced or cleaned.
This function activates independently
after 40 hours of operation for grease
filter and 160 hours of operation for
charcoal filter.
Refer to Cleaning the grease filter in the
Care and cleaning chapter.
Refer to cleaning the charcoal filter or
replacing the charcoal filter in Care and
cleaning chapter.
To reset the function counter in the
notification period, touch the
6. CARE AND CLEANING
6.1 Notes on cleaning
Cleaning Agents
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth
with warm water and a mild detergent.
After cooking some parts of appliance can get hot. To
avoid stains appliance must be cooled down and
dried with clean cloth or paper towels.
Clean stains with a mild detergent.
Keep the hood clean
Clean the appliance and grease filters each month.
Clean the interior and grease filters carefully from fat.
Fat accumulation or other residue may cause fire.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and
a short cycle. The grease filter may discolour, it has
no influence on the performance of the appliance.
Charcoal filter
The time of saturation of the charcoal filter varies de‐
pending on the type of cooking and the regularity of
cleaning the grease filter. Refer to leaflet included in
the accessory.
seconds. The symbol stops blinking for the
correct reset.
The function counter for charcoal filter is
disabled by default. For recirculation
mode, it must be activated.
To activate or deactivate the counter for
charcoal filter:
1. Switch on the control panel.
2. Make sure the fan and the light are turned
3. Touch the
The function is activated if symbols
blink once. The function is deactivated if
symbols
symbol for 3
Before carrying out any maintenance,
make sure there is no cookware on the
hob and that the hood and the hob are
disconnected from the power supply.
6.2 Cleaning the grease filter
There are two grease filters. One situated
underneath and the other at the front side of
the appliance.
Filters are mounted with the use of clips and
pins on the opposite side.
To clean the filter:
1. Pull the cover to open it.
66
off.
symbol for 3 seconds.
and
blink twice.
1
and