Airzone Aidoo Pro AZAI6WSP Serie Manuel D'utilisation page 18

•
Airzone system gateway. Configures the integration port so that the device functions as
a communication gateway. Once set, the usual settings that can be made on the Aidoo
device are disabled and only the device information section will be visible.
•
Modbus RTU Airzone. Configures the integration port for communications using the
Modbus RTU protocol.
•
BACnet MS/TP Airzone. Configures the integration port for communications using the
BACnet MS/TP protocol.
EN
Indoor unit information
The indoor unit information will depend on the model of
the unit and the manufacturer. The parameters that can be
shown in this section are as follows:
Manufacturer*.
Thermostat units*. Allows you to select the units in which
the manufacturer's thermostat will work (°C or °F).
Works with external temperature reading devices*.
External temperature reading device active.*
Third party thermostat temperature.
Zone temperature.*
Working temperature.*
Return temperature.*
Exchanger temperature.*
Outdoor unit information
The outdoor unit information will depend on the model of
the unit and the manufacturer. The parameters that can be
shown in this section are as follows:
Consumption.*
Outdoor temperature.*
Exchanger temperature.*
Compressor discharge temperature.*
Evaporation pressure.*
Condensation pressure.*
Simulation Mode*. This allows you to activate Simulation
Mode, interrupting
Any change to a parameter while this mode is active will
not be reflected in the unit. By default, this parameter is
deactivated.
* Not available in Bluetooth configuration.
18
communications with the unit.