Publicité
WARNING: High Pressure hoses, fittings, and couplings are important for the safety of the
appliance. Use only fittings and couplings recommended by the manufacturer.
Do not use the appliance, if a supply cord or important parts are damaged, e.g. safety devices,
high pressure hoses, trigger gun.
WARNING: Incorrect fuels shall not be used as they may prove hazardous.
WARNING: Do not use combustion engine powered appliances indoors unless adequate
ventilation is assessed by national labour authorities.
WARNING: Ensure that any exhaust emissions are not in the vicinity of air intakes.
7 SAFETY WARNINGS GASOLINE
WARNING: Use extra care in handling fuels. They are flammable and the vapours are
explosive. The following points must be observed.
▪
Use only an approved container.
▪
Never remove the fuel cap or add fuel with the power source running. Allow engine
exhaust components to cool before refuelling.
▪
Do not smoke.
▪
Never refuel the machine indoors.
▪
Never store the machine or fuel containers inside, where is an open flame, such as a
water heater.
▪
If fuel is spilled, do not attempt to start the power source, but move the machine away
from the area of spillage before starting.
▪
Always replace and securely tighten the fuel cap after refuelling.
▪
If the tank is drained, this should be done outdoors.
8 SAFETY FEATURES
8.1
Thermal relief valve
A thermal relief valve is provided to protect the pump from overloading if the spray gun is
closed for an extended length of time or the nozzle becomes plugged. However, it is intended
to be used as a backup system and avoid the overheating of the pump.
Switch the pressure washer "OFF", if it will not be used for longer than five minutes. This
reduces wear, prevents fuel consumption and extends the live of the pump by avoiding heat.
8.2
Safety lock off latch
To prevent accidental discharge of high pressure water, the safety latch on the trigger should
be engaged whenever the pressure washer is not in use (refer to operating instruction).
8.3
Water temperature protection
If the water temperature in the pump is higher than 50 °C, the protection valve will open and
release the hot water to protect the pump. And after the hot water is out, the valve will close
again.
9 ASSEMBLY INSTRUCTIONS
Remove all packaging materials from the unit. Check the main unit, its components and all
accessories for loss and transport damages.
9.1
Assembly of the wheels (Fig. 1)
Drive the axle through the centre hole of the wheel until the pin is blocked.
▪
Assemble the wheel on the axle and fix it with a nut.
9.2
Assembly of the hose reel (Fig. 2)
▪
In the direction of the arrow, fix the hose reel on the frame.
▪
In the direction of the arrow, insert the handle into the frame, lock it by lock catch A.
▪
In order to avoid the hose reel moving, fix it with screw and nut.
9.3
Assembly of the handle (Fig. 3)
▪
In the direction of the arrow, insert the handle into the mounting hole of hose reel
Copyright © 2024 VARO NV
POWXG9100
P a g e
| 6
EN
www.varo.com
Publicité
