Publicité
EN
CHANGING THE
ATTACHMENT
Please Note!
■
A damaged / worn attachment can
cause injuries to the skin and must be
replaced.
1. Grip the protective cap (1) at the level
of the two recesses on the ring (2) and
pull it off.
2. Grip the attachment (8) at the level of
the two recesses on the ring and pull it
off the device.
3. Place another or new attachment on
the mount and press it on firmly. It must
engage audibly.
USE
Please Note!
■
Clean the attachments before you first
use them as they may have possible
production residues on them. Follow
the instructions in the "Cleaning and
Storage" chapter to do this.
■
The device should only be used with
a correctly applied attachment!
■
Only use the device on uninjured calluses
on your feet.
■
Do not use the device on tender, soft skin.
■
Do not press the attachment against the
skin with force. It could be injured.
■
From time to time, check the area you
are treating to avoid penetrating your
skin too deeply and causing injuries. Do
not hold the attachment on one spot for
longer than 2 to 3 seconds.
■
If you experience an unpleasant sensa-
tion while you are using the device, stop
applying it immediately!
14
06200_14016_DE-EN-FR-NL_A5_V5.indb 14
06200_14016_DE-EN-FR-NL_A5_V5.indb 14
Removal of Calluses
L
For dry application, make sure that
there are no cream or care oil resi-
dues on your feet.
1. Connect the device to the mains power
via the USB cable or insert batteries (see
the "Power Supply" chapter).
2. Grip the protective cap (1) at the level
of the two recesses on the ring (2) and
pull it off.
3. Place the required attachment (8) on the
device (see the "Changing the Attach-
ment" chapter).
4. Slide the On / Off switch (3) to the ON
position to switch on the device. The
attachment starts to rotate and the
suction function is activated.
5. Place the rotating attachment against
the callus and move the device back and
forth and to the sides. Move the device
slowly and without pressure.
L
If the device is pressed too firmly
against the skin, the attachment
will automatically come to a stop to
prevent skin injuries.
6. Switch off the device after use by sliding
the On / Off switch to the OFF position.
After Treatment
1. Apply cream to the feet so that the skin
becomes soft and tender.
2. Clean the device after each use (see the
"Cleaning and Storage" chapter).
22.08.2024 11:57:39
22.08.2024 11:57:39
Publicité
