Publicité
Les langues disponibles
Les langues disponibles
Retro tting luminaire with MULTIPLE LAMPS
After completing steps 1 - 3 above, connect terminals on the "powered" lamp holder for rst lamp to
matching terminals on "powered" lamp holder for second lamp with black (live) and white (neutral) wires,
being sure to maintain polarity. Repeat this "daisy chain" connection for each additional lamp.
1 L E D Tu be
B L A C K
W H IT E
4 L E D Tu be
B L A C K
W H IT E
4. When all connections are complete, place appropriate connectors/wire nuts on the end of any unused wires.
5. Replace wiring compartment cover.
6. Place sticker that is included with this product on wiring compartment cover or other conspicuous place
on or inside of xture. Sticker reads: "This xture has been modi ed. The ballast has been removed. DO
NOT install uorescent lamps in this xture".
7. Install LED tube(s), matching the end of the lamp that has the "L/N" sticker to the lamp holder that is
connected to the Live and Neutral wires.
8. Re-connect power to luminaire.
WARNING :
Risk of re or electric shock. Installation of this Retro t requires knowledge of electrical systems. If you are not
quali ed, do not attempt installation, and contact a quali ed electrician.
Install this kit only in luminaires that have the construction features and dimensions shown in the photographs
and drawings.
Do not make or alter any open holes in an enclosure of wiring or electrical components during installation.
To prevent damage to wiring, do not expose wires to the edges of sheet metal or other sharp objects.
WARNING: To aviod potential re or shock hazard, do not use this retro t kit in luminaires employing shunted
bi-pin lampholders. Notes: Shunted lamp holders are found only in uorescent luminaires with Instant-Start
ballasts. Instant-Start ballasts can be identi ed by the words "Instant Start" or "I.S." marked on the ballast. This
designation may be in the form of a statement pertaining to the ballast itself, or may be combined with the
marking for the lamps with which the ballast is intended to be used, for example F40T12/IS. For more
information, contact the LED luminaire retro t kit manufacturer.
L E D Tu be 1
L E D Tu be 1
L E D Tu be 2
L E D Tu be 3
L E D Tu be 4
2 L E D Tu be
B L A C K
W H IT E
3 L E D Tu be
B L A C K
W H IT E
3
L E D Tu be 1
L E D Tu be 2
L E D Tu be 1
L E D Tu be 2
L E D Tu be 3
ESF-WH-019
Publicité
