3. Operating Instruction on Control Panel
When the Power is ON, you will hear a "Tik" sound from control panel indicating electrical connection
is good and will function normally.
(1) POWER ON/OFF: Press and hold the power button
same operation to turn off the power.
(2) CHROMO THERAPHY LIGHT ON/OFF: When power is on keep touching the Left and Right
buttons until the cursor on the LCD is on the Chromo Therapy light position
the OK
button and the light will work; repeat the same operation to turn off the light.
(3) AIR BUBBLE ON/OFF: When power is on, keep touching the Left and Right
the cursor on the LCD is on the Air Bubble position
bubble blower will start to function;repeat the same operation to turn off the Air bubble blower
(4) WAVE MASSAGE ON/OFF: When power is on, keep touching the Left and Right
buttons until the cursor on the LCD is on the Wave Massage
button, the Wave massage will start to function and repeat the same operation to turn off the
wave massage. (Make sure there is enough water inside the tub)
(5) HEATER ON/OFF: ONLY FUNCTION when wave massage is running. When power is on
keep touching the Left and Right
position and press the OK
(6) TEMPERATURE SETTING: When heater is running, press the function
digital twinkle on display temperature on LCD display. Press the Left/Down
the temperature by 1˚F, press the Right/Up
Air Blower Speed Setting.
Press Air blower button, it will starts off in the highest speed, press again for medium speed, press
again for low speed and press again to turn off the blower. (Air Blower speed default from high to low)
* 1st Press: Turn On and in hight speed
* 2nd Press: Medium speed
* 3rd Press: Low speed
* 4th press: Turn off air blower
** DO NOT Power on the water pup if there is no enough water inside the tub.
** The setting temperature range is between 90˚F to 110˚F (32˚C – 43˚C)
7
,press the OK
buttons until the cursor on the LCD is on the Thermostat
button to turn on, repeat the same operation to turn it off.
button to increase the temperature by 1˚F
for 2 seconds to turn it on. Repeat the
button and the air
position, then press OK
button until the
button to decrease
, press
buttons until