Télécharger Imprimer la page

Woodbridge BJ100 Guide D'installation Et D'entretien

Air et baignoire à remous avec fonction de chauffage

Publicité

Liens rapides

INSTALLATION AND CARE GUIDE
AIR AND WHIRLPOOL HEATED BATHTUB
BJ100
BJ500
Certified to the following Codes & Standard:
• UL 1795 Safety Standard for Hydromassage Bathtubs
• ASME A112.19.7 / CSA B45.10) – Hydromassage Bathtub Systems
• CSA B45.5/IAPMO Z124 – Plastic Plumbing Fixtures
• International Plumbing Code
• International Residential Code
• Uniform Plumbing Code
National Plumbing Code of Canada
READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT
Must hire a licensed electrician to install a dedicated 120V, 30 Amp circuit breaker for the BJ/BM/BG
-series-hardwired 3-in-1whirlpool tubs. The electrician also needs to verify the connected electrical wiring
can handle a 30 Amp current.
WOODBRIDGE is not responsible for product damage/malfunction caused by incorrect electrical installation.
WOODBRIDGE is also not responsible for property damage caused by incorrect electrical installation.
INSTRUCTIONS THAT, IF IGNORED COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING
OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION.
This products must be installed by a fully insured and licensed plumber only. Installation of any our product by anyone other
than fully insured and licensed plumber shall void limited warranty. We recommen that such licensed plumber has experience
in the installation of products.
We are not responsible for local code compliance for this product. Building and plumbing codes may vary from state-to-state in
accordance to your location. We are not responsible for providing any compliance certifications.
Under no circumstances we shall not be liable for any incidental damages sustained in connection with this product
Neither manufacture, nor distributor, nor retailer is responsible for water damage or flood caused due to use of this product.
Under no circumstances we shall not be liable for any and all fees, cost of installation/reinstallation/removal, subsequent
damage or transportation in case of the product defect
Customer Service Phone: 562-229-0088. (Monday - Friday 9 AM - 5 PM Pacific Standard Time)
BJ400
BM400
BG500
BJ600
® (IPC)
® (IRC)
® (UPC)
® (NPC)
Or Email: help@woodbridgebath.com
BG400
BJ700
2 PEOPLE ARE REQUIRED TO LIFT AND DURING
ENTIRE INSTALLATION OF THIS PRODUCT
BM500
BJ061
(UL1795)

Publicité

loading

Sommaire des Matières pour Woodbridge BJ100

  • Page 1 WOODBRIDGE is not responsible for product damage/malfunction caused by incorrect electrical installation. WOODBRIDGE is also not responsible for property damage caused by incorrect electrical installation. INSTRUCTIONS THAT, IF IGNORED COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT.
  • Page 2 • All information is based on the latest product information available at the time of ® publication. WOODBRIDGE reserves the right to make changes in product characteristics, packaging, or availability at any time without notice. PRODUCT REQUIREMENTS A.
  • Page 3 BJ600 72" 47-1/4" 13 3/4" Water depth Hydromassage Pump Control box 68-7/8" 3-7/8" Direct connect Heater Air Blower to breaker BJ700 71" 44" 6-3/4" 14 1/2" Water depth Heater Air Blower Control box 60-5/8" 5-1/8" 16-1/8" Hydromassage Direct connect 15" Pump to breaker BJ061...
  • Page 4 INSTALLATION REQUIREMENTS A. Tools Required B. Materials Required: • Adjustable pipe • Plumbers putty • wrench • Wall coverings, as necessary • Ruler • Silicone sealant • Level • Gypsum cement (optional) • Safety shoes • Construction adhesive (optional) • Safety glasses •...
  • Page 5 30 Amp current. WOODBRIDGE is not responsible for product damage/malfunction caused by incorrect electrical installation. WOODBRIDGE is also not responsible for property damage caused by incorrect electrical installation. For Air Bath and Whirpool Tub installation, Do not apply any silicone sealant after installation, leave a 5-10mm(0.2"...
  • Page 6 WHIRLPOOL & AIR & HEATER 3-in-1 JETTED TUB (for single Hardwired model only) CLARIFICATION: WOODBRIDGE has two types of jetted tubs. This diagram is for the model with all functions combined into one single wire that needs to be hardwired.
  • Page 7 1. Schematic diagram for main control box PANEL MAIN CONTROL BOX TO HEATER LIGHT HEATER PUMP BLOWER 2. Control Panel lcons BJ100 BJ500 BM500 BG500 BJ600 display window Power Function Right/Up Left/Down OK button Chromo Theraphy light Wave Massage Thermostate...
  • Page 8 3. Operating Instruction on Control Panel When the Power is ON, you will hear a “Tik” sound from control panel indicating electrical connection is good and will function normally. (1) POWER ON/OFF: Press and hold the power button for 2 seconds to turn it on. Repeat the same operation to turn off...
  • Page 9 4. Schematic diagram of the panel BJ400 BM400 BG400 BJ700 Display Window Wave Massage ON/OFF Air Blower ON/OFF Bottom light ON/OFF Power ON/OFF switch Thermostate Air Blower Speed Setting. Press Air blower button, it will starts off in the highest speed, press again for medium speed, press again for low speed and press again to turn off...
  • Page 10 5. Operating Environment (1) Power: AC 110V (2) Bottom Lights: AC 12V (3) Wave massage, Air Blower: AC 110V (4) Heater: AC 110V 6. Caution 1. Carefully read this user manual before you operate this unit and keep this user manual for future reference. 2.
  • Page 11 Improper care and use of abrasive cleaners and will void the warranty. During this limited warranty period if a malfunction occurs and after inspection it is determined that a defect developed during normal use, Woodbridge will as at...
  • Page 12 Abrasive sponges or cloth. Never use steel, wool, or wired brushes that will permanently scratch the Retain these installation instructions for future reference! Thank you for using WOODBRIDGE products! Please don't hesitate to contact us if you have any questions or concerns.
  • Page 13 3 en 1 de la série BJ/BM/BG, et vérifier que le câblage électrique peut supporter un courant de 30 ampères. Woodbridge décline toute responsabilité pour les dommages ou défaillances du produit ainsi que pour les dommages matériels résultant d'une installation électrique incorrecte.
  • Page 14 • Toutes les informations sont basées sur les dernières informations disponibles au moment de la ® publication. WOODBRIDGE se réserve le droit de modifier les caractéristiques des produits, leur emballage ou leur disponibilité à tout moment et sans préavis. EXIGENCES EN MATIÈRE DE PRODUITS A.
  • Page 15 BJ600 72 po 47-1/4 po Profondeur 13 3/4 po de l'eau Pompe d'hydromassage Boîte de contrôle 68-7/8 po 3-7/8 po Connexion directe Souffleur d'air Chauffe-eau au disjoncteur BJ700 71 po 44 po 6-3/4 Profondeur 14 1/2 po de l'eau Chauffe-eau Souffleur d'air Boîte de contrôle 60-5/8 po...
  • Page 16 EXIGENCES EN MATIÈRE D'INSTALLATION A. OUTILS NÉCESSAIRES: B. Matériel nécessaire: • Clé à pipe réglable • Mastic de plombier • Clé à molette • Revêtements muraux, si • Règle nécessaire • Niveleur • Produit d'étanchéité à base • Chaussures de sécurité de silicone •...
  • Page 17 3 en 1 câblées de la série BJ/BM/BG. L'électricien doit également vérifier que le câblage électrique connecté peut supporter un courant de 30 ampères. WOODBRIDGE n'est pas responsable des dommages / défaillances du produit résultant d'une mauvaise installation électrique.
  • Page 18 Baignoire à jets 3 en 1 (pour le modèle simple câblé uniquement) CLARIFICATION: WOODBRIDGE propose deux types de baignoires à jets. Ce schéma concerne le modèle dont toutes les fonctions sont réunies en un seul fil qui doit être câblé.
  • Page 19 1. Schéma de principe du boîtier de commande principal BOÎTE DE PANEL CONTRÔLE PRINCIPALE CHAUFFAGE LUMIERE RÉCHAUFFEUR POMPE SOUFFLEUR 2. Panneau de contrôle lcons BJ100 BJ500 BM500 BG500 BJ600 Fenêtre d’affichage Alimentation / Fonction Droite / Haut Gauche / Bas Bouton OK Lumière...
  • Page 20 3. Instructions d'utilisation sur le panneau de contrôle Lorsque l'appareil est sous tension, le panneau de commande émet un son “Tik” indiquantque la connexion électrique est bonne et que l'appareil fonctionnera normalement. (1) MARCHE/ARRÊT: Appuyez sur le bouton d'alimentation et maintenez-le enfoncé pendant 2 secondes pour mettre l'appareil sous tension.
  • Page 21 4. Schéma de principe du panneau BJ400 BM400 BG400 BJ700 Fenêtre d'affichage Massage par vagues ON/OFF Ventilateur ON/OFF Éclairage du fond ON/OFF Interrupteur marche/arrêt Thermostat de l'alimentation Réglage de la vitesse soufflerie d'air. Appuyez sur le bouton de la soufflerie d'air, elle se met en marche à la vitesse la plus élevée, appuyez à nouveau sur le bouton pour une vitesse moyenne, appuyez à...
  • Page 22 5. Environnement opérationnel (1) Alimentation : AC 110V (2) Lumières inférieures : AC 12V (3) Massage à vagues, soufflerie d'air : AC 110V (4) Chauffage : AC 110V 6. Attention 1. Lisez attentivement ce manuel avant d'utiliser l'appareil et conservez-le pour toute référence ultérieure. 2.
  • Page 23 Cette garantie limitée exclut tout usage industriel, commercial et professionnel. Une preuve d'achat (ticket de caisse original) de l'acheteur original, une description et des photos du défaut, le numéro ou la description du modèle doivent être fournis à Woodbridge Bath pour toute réclamation au titre de la garantie et Woodbridge Bath N'EST PAS responsable des coûts de main-d'œuvre, d'enlèvement ou d'installation.
  • Page 24 Conservez ces instructions d'installation pour référence future! Merci d'utiliser les produits WOODBRIDGE! Si vous avez des questions ou des préoccupations, n'hésitez pas à nous contacter. Téléphone du service à la clientèle: 562 -229 -0088. (9 h à 17 h, heure normale du Pacifique, du lundi au vendredi) ou par courriel à: help@woodbridgebath.com...

Ce manuel est également adapté pour:

Bj400Bm400Bj500Bm500Bj600Bj700 ... Afficher tout