Publicité
INSTALLATION REQUIREMENTS
A. Tools Required
• Adjustable pipe
• wrench
• Ruler
• Level
• Safety shoes
• Safety glasses
• Square
• Screwdriver
• Pliers
• Utility knife
C. Clearance Requirements:
Check the rough-in and room dimensions to provide adequate space for the bath unit.
SITE REQUIREMENTS
A. Plumbing Preparation
Position the plumbing according to rough-in dimensions.
Cap the supplies and check for leaks.
BEFORE INSTALLING UNIT
CAUTION:Ensure a watertight seal on the bath drain connections.
A. Install the faucet valving and shower head tee.When drilling bathtub for faucet,
ensure sufficient clearance. Open the hot and cold water valves and check the
supply connections for leaks.
B. Run water into the bath and check the drain connections for leaks.
C. Fill the bathtub up to the overflow level and check overflow unit for leaks.
INSTALL BATHTUB
This products must be installed by a fully insured and licensed plumber only.
1) Your new bathtub has been manufactured to the highest possible standards,it has been tested
and approved by factory.
2) When removing the bathtub from the protective carton.
DO NOT LIFT THE BATHTUB BY HOLDING PIPE CONNECTION under the bathtub.
* Inspect for any possible damage that may have occurred in transit.
* Check the connection of the hose and drain, tighten if loose. They may have loose during the transition.
IMPORTANT: Bathtub must be installed level on all top edges.
3
B. Materials Required:
• Plumbers putty
• Wall coverings, as necessary
• Silicone sealant
• Gypsum cement (optional)
• Construction adhesive (optional)
• Protective covering for bathtub
• Nails
Publicité
