Publicité
WOODBRIDGE
3-in-1 JETTED TUB (for single Hardwired model only)
CLARIFICATION:
with
all functions combined into one single wire that needs to be hardwired.
come with a power plug.
MUST
to ONE dedicated
120V, 30A
circuit breaker
Hydromassage
Control box
Pump
Tub inline heater is
designed to
the water temperature.
It does
heat up the water.
!! Do
connect the
wire to another
"HOT" wire
!! Do
connect to a
240V power
!! Do
connect to insufficient
5A / 10A / 15A /
20A / 25A Power
IMPORTANT ELECTRICAL TESTING PROCEDURE:
When testing the electrical components and the wiring, please
whirlpool jet cannot to be turned on unless the tub is filled up.)
jet, air bubble blower, and set the heater to 104°F(40°C) AT THE SAME TIME.
for 15 minutes.
(* If the water is already hotter than 104°F(40°C), you will need to set the inline heater at a higher temperature.)
If your breaker is tripped and the power is stopped, that means your circuit breaker may
be powerful enough (less than 30 Amp). Please have an electrician to check/upgrade your
electrical system.
5
R
WHIRLPOOL & AIR & HEATER
WOODBRIDGE has two types of jetted tubs. This diagram is for the model
IMPORTANT:
connect
Must use a certified electrician to verify and to install your
electrical system, including the breaker, wiring, outlets,
switches, etc. Incorrect electrical installation will damage the
tub and void the warranty.
Heater
120V,30 AMP
(BLACK
The best way to use the tub inline heater: First, use a faucet (not
included) to fill up the tub with water at a desirable temperature,
MAINTAIN
such at 100 °F (38 °C). Second, set the heater to 100 °F (38 °C).
The heater will be activated when the water temperature drops.
NOT
rapidly
If you fill up the tub with room temperature water, such as at
65 °F (18°C), it may take 2-3 hours for the water to reach 100 °F
(38 °C), if ever.
WARNING:
NOT
Do
NOT
WHITE
wire. The
Only
Incorrect wiring will damage the tub and void the warranty.
(You may need to purchase a replacement control box or transformer to fix this mistake.)
You will overload and damage the electrical components
NOT
instantly. This will void the warranty.
(You may need to purchase a replacement control box or transformer to fix this mistake.)
Insufficient power will trigger your circuit breaker to stop the
NOT
power supply. The tub will stop working.
You may also damage the electrical components. This voids the
warranty.
N
Neutral
wire)
(WHITE
wire)
(* Actual heating speed will vary based on environmental factors.)
connect the
WHITE
wire on the tub to another "HOT"
WHITE
wire on the tub is the
connect the
BLACK
wire on the tub to 110V "HOT" wire.
1.
2.please turn on the whirlpool
This unit does
Ground
(GREEN
wire)
Neutral
wire.
fill up the tub first. (The
3.Please let it run
NOT
NOT
Publicité
