Publicité
Manual_SRU5170_86
Instructions for use
4. Extra possibilities
Adding extra functions
Note: Only functions that are available on the original device remote controls can be added.
1
Keep XTRA pressed for 3 seconds:
–
- the backlight (if enabled) turns on.
- the display shows '
- the keys that can be used are blinking.
Use 3 and 4 to select the extra function you wish to add
2
or change. Confirm with OK.
–
The display shows '
3
Place both remote controls on a flat surface (like a
coffee table) and aim them head-to-head with about
5 - 10 cm in between.
4
Press the function key on the original remote control
(e.g. the AMBILIGHT key on your TV remote control) or
press 1 if you wish to return to step 2.
–
The display shows '
The extra function has been added successfully.
–
If the display shows 'ERROR' or 'MEM FULL', start again from step 1.
Also see 'Troubleshooting' under 6. 'Support'.
Activating / using an extra (advanced) function
1
Use SELECT to select the desired device. E.g. DVD.
–
Confirm with OK.
2
Press XTRA.
–
The last selected function for the device appears on the
display. E.g. DVD-SHOWVIEW.
The keys that can be used are blinking.
Use 3 and 4 to select the function you wish to activate.
3
E.g. DVD-ZOOM. Press OK to activate the function.
4
Press XTRA again to go back to normal operation mode.
Delete devices
Example of TV:
1
Keep SETUP pressed for 3 seconds:
–
the backlight (if enabled) turns on.
–
the display shows '
–
the keys that can be used are blinking.
8
24-04-2007
15:48
' and '
', '
' and '
' together with e.g. 'TV-AMBILIGHT LEARN OK'.
', '
' and 'TV?'
Pagina 8
'.
' together with 'LEARNING'.
Publicité
