Publicité
CTP 1840
Starting under chin, ascend along the cheek in the direction of the ear. Measure in different directions to
cut all the isolated hairs.
To lighten or trim the beard, use a small level so that the hairs do not bend. With the help of the
opposite hand, hold the clipper -sharp cutter to the outside- while slowly sliding the appliance along the
head.
SHAVER:
Use the shaver attachment to clean-up detailed areas. For best results, avoid holding at an angle.
EARS:
When trimmer inner ears, avoid inserting Grooming System (3) more than 1/4" into ear canal.
Rotate Grooming System in a circular motion while gently moving in and out of ear canal.
EYEBROWS:
Guide cutting edges to stray hairs along eyebrows with accessory (3).
For best results, do not use the grooming system to define entire eyebrow.
NOSE:
Insert the hair clipper delicately (accessory 3) and do not put the device more than 1 cm inside the nose.
Apply a rotating movement to the device during insertion and removal from the nose.
SIDEBURNS AND NAPE OF NECK:
Use the profiling accessory (7) for the sideburns and the beard trimmer attachment (5) for the neck.
Place the blades on the face and mark the desired shape of the sideburns.
For the neck, it is necessary to use a hand mirror, if you cut the hair without help.
Lift the hair from the nape of the neck, using your index finger to cover and protect the hair that does
not need to be cut.
Gently place the knives on the nape of the neck and move the clipper slowly upwards until it meets your
index finger.
CLEANING, CARE & MAINTENANCE
NOTE: Always clean Grooming System attachments regularly to ensure best performance and a proper
operating life.
CLEANING ATTACHMENTS WITH WATER
1. Remove attachment.
2. Rinse ONLY the attachment under warm running water. DO NOT use hot water ad this might cause
damage.
CLEANING ATTACHMENTS WITH BRUSH
After first removing attachment, thoroughly brush and blow out hair clippings from cutting system,
attachment, and top of power handle.
17
Publicité
