Publicité
Grinding pins, glass/stone/ceramic, various
shapes (9)
For cutting + engraving glass, stone and ceramic.
Recommended speed setting: ≤ 4
Cutting pins, various shapes (10)
For cutting + engraving plastic, wood, soft metal
and glass.
Recommended speed setting: ≤ 4-6
Grinding pins, metal, various shapes (11)
For grinding and deburring metal.
Recommended speed setting: ≤ 4
Cup brush (12) / round brush (13)
For cleaning metal, aluminium, etc.
Recommended speed setting: ≤ 2
Cutting wheels, large/medium/small (14)
For cutting plastic, wood and metal.
Recommended speed setting: ≤ 5
Grinding belts, large/small (15)
For grinding/sanding wood and plastic.
See Fig. 9 for fi tting.
Recommended speed setting: ≤ 6
Felt polishers, large/small/high (20)
For polishing brass, tin, copper, etc.
Also for use with polishing pastes.
See Fig. 10 for fi tting.
Recommended speed setting: ≤ 3
Grinding wheels, red/green (21)
For cleaning metal and grinding wood and fi ber-
glass.
See Fig. 11 for fi tting.
Recommended speed setting: ≤ 3
Cutting-off wheels (22)
For cutting metal and plastic.
See Fig. 11 for fi tting.
Recommended speed setting: ≤ 6
Chuck key (16)
For mounting accessories.
Clamping sleeve, 1.6 / 2.4 / 3.2 mm (23)
Various sizes for holding diff erent accessories.
Clamp nut (24)
For clamping the accessories.
Anl_TC_MT_150_E_SPK13.indb 17
Anl_TC_MT_150_E_SPK13.indb 17
GB
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Danger! The carbon brushes should not be rep
laced by anyone but a qualifi ed electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
- 17 -
07.05.2024 13:30:40
07.05.2024 13:30:40
Publicité
