Publicité
EN
Safety instructions
1. Check the weighing performance of the scale before it is used every day and stop using it if it is operating abnormally.
2. It is strictly prohibited to overload the scale at any time. If the scale is overloaded, its load cell may be damaged.
3. Recharge the scale when the [LobAt] indication is displayed. Otherwise, the life span of the battery will be affected.
Technical Data
- Model: DS1000
- Weighing capacity: 30 kg
- Subdivision: 1 gr
- Platform dimensions: 25x18 cm
- Rechargeable
- LCD display
Operating instructions
The scale should be placed in the floor that is stable and flat and can be adjusted to the horizontal position by adjusting four feet
at the bottom of the scale.
Turn on/off: The scale is turned on by pressing the [ON/OFF] key, [SFn-xx] is displayed in WEIGHT window, xx for weighing
capacity, and then self-checking goes on, and then the scale can be used after ''0'' is displayed in the window. The scale turns off
by pressing the [ON/OFF] key again.
Zeroing: In case the reading on the display is not zero when a load is not placed on the scale, press the [ZERO] key in order for the
displayed value to return to zero. (Zero ranges: ≤4%FS, it is not effective when it is tared)
Tare: By pressing the [TARE] key, the displayed value will be zeroed. When the lamp for the tare is lit, the net weight is displayed.
After removing the weight already placed on the scale, the negative weight is displayed. By pressing the [TARE] key, the displayed
value will be zeroed returns to the zero and the lamp for the tare will turn off. (Tare ranges: ≤100%FS, i t is not effective when the
weight is negative)
LED brightness: The LED brightness can be adjusted by pressing the [FUNCTION] key.
Power saving: The scale will automatically enter into the energy saving status after a few seconds when the WEIGHT window
displays [0.0] and a load is not placed on the scale.
Backlight (if available)
When the [TARE] key is pressed for three seconds, the backlight will turn on. Press the [TARE] key again to turn off the backlight.
SPEED CHANGE: Press and hold the [FUNCTION] key and the [ZERO] key for three seconds and after the ''-----X'' indication
appears, it means that the speed has been changed. X refers to the speed mode, 1: quickest speed, 3: slowest speed.
UNIT CHANGE: By pressing and holding the [FUNCTION] key, the weight units can be changed. (g and kg, or Lb. and kg)
AUTOMATIC OFF: The scale turns off automatically when the [LobAt] indication is displayed for 10 seconds. When the voltage is
not sufficient, the [LobAt] indication will be displayed every 1 minute and then the scale will turn off after 8 times when weighing.
Attention
For the battery: When the [LobAt] is displayed on the screen while the scale is turned on and weighing a load, it means that the
battery power is not enough. The battery must be recharged in time, otherwise the life span of the battery will be shortened.
2
WWW.NIKOLAOUTOOLS.COM
Publicité
