Troubleshooting; Technical Data - DS Produkte Z 09268 Mode D'emploi

Troubleshooting

If the device stops working properly, fi rst check whether you are able to correct the
problem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The handle and the
handlebar do not fi t
together/the handle
does not lock into
place.
The device is not
working. /
The power LEDs
are not illuminating.
No steam is
released.

Technical data

Model number:
Product number:
Power supply:
Safety class / level:
Water tank capacity:
29
Potential cause / solution
It is possible that the cable winder becomes twisted at the
handle during the production process. This prevents the
handle from locking into the handlebar. Turn the cable win-
der slightly at the handle until the handlebar fi ts directly into
the opening. When the latch locks into place, the handle has
been securely connected with the handlebar.
• Is the plug properly connected with the socket?
• Is the socket defective? Try another socket.
• Check the fuse for your mains connection.
• Have you pushed the On / Off switch (4) on the front of the
main unit? Please note: The switch on the back (13) is
deactivated when the handle bar has been inserted.
• Has the steam quantity been set high enough? Turn the
knob for the steam quantity control clockwise to increase
the amount of steam.
• The device is still not operational. The device must heat up
for a few seconds until steam can be emitted.
• The water tank is empty. Fill the water tank (see chapter
"Filling the water tank").
• Has the tank been properly inserted in the main unit?
Check to make sure it is properly seated.
• The nozzle is plugged. Clean the nozzle.
JJ-SC-005B
Z 09268
220–240 V~, 50 Hz, 1500 W
I, IPX4
max. 350 ml, approximately 20 minutes operating time
when the tank is full
EN