Glatz SUN Comfort FLEX ROOF Mode D'emploi page 11

GB Setting up the balcony roof
Bases with a minimum weight of 40 kg and a base tube diameter of 32 mm are suitable
•
for the safe assembly of the balcony roof. Alternatively, a balcony clamp ( Ø 32 mm )
can also be used.
ATTENTION: Base and balcony clamp are not included in the delivery.
•
Ensure that no objects or people are in the assembly area.
•
Assemble the joint. Fig.
•
Join lower pole and top pole together ( top pole must be fully inserted into the lower
•
pole ). Fig.
Tighten locking screw firmly so that the roof cannot twist. Fig.
•
Attach the lower pole to the base. Attention: when using on a balcony, the roof element
•
( frame ) should be in a horizontal position. Fig.
Opening the roof
Put the roof element ( frame ) in a horizontal position. Fig.
•
Unfasten the ties and lightly shake the material.
•
To tauten the roof, push the slides out left and right successively until they lock in
•
place. Fig.
Set the balcony roof to the desired height.
•
To tilt, incline or move the roof element, the locking screw on the pivot joint must be
•
loosened. Fig.
ATTENTION: When loosening the locking screw it is essential to hold the roof
•
element tightly so that it cannot tip over independently.
Closing the roof
Put the roof element ( frame ) in a horizontal position. Fig.
•
Put the roof in the lowest possible position: to do this, hold the top pole tightly, loosen
•
the locking screw on the lower pole and then slowly lower the roof element.
Loosen the slides successively and push them to the middle until the stop ring.
•
Fig.
Fold the cover and fasten it together with the ties.
•
Turn the roof frame lightly to the inner side of the balcony and bring it into an upright
•
position. Fig.
Protecting the balcony roof
• Protect your sunshade with the protective cover supplied.
To use the protective cover, bring the roof element into a horizontal position and bind
•
the sunshade material together. Fig.
Pull the protective cover up to the rotation joint. Fig.
•
Bring the roof element into an upright position, pull the protective cover all the way
•
down and close it with the Velcro fastening. Fig.
2b
11