Publicité
Fan Without Light Kit (Optional)
1. Disassemble the switch housing cover from the light kit by
removing the nut and washer on the centre of the switch
housing cover. Keep the light kit for future use (see Fig. 11).
2. Attach the plastic plug to the switch housing cover.
3. Install the switch housing cover to the switch housing with
screws provided.
The following procedure should correct most fan wobble. Check
after each step.
1. Check that all blade and blade bracket screws are secure.
2. Most fan wobble problems are caused when blade levels are
unequal. Check this level by selecting a point on the ceiling
above the tip of one of the blades. Measure from a point on the
center of each blade to the point on the ceiling as shown.
in Fig.12. Rotate the fan until the next blade is positioned
for measurement. Repeat for each blade. Measurements
deviation should be within 1/8" (3.2 mm). Run the fan for
10 minutes.
3. Use the enclosed blade balancing kit if the blade wobble is
still noticeable.
All manuals and user guides at all-guides.com
Blade Balancing
8
Switch housing
Switch
housing
cover
Plastic plug
Fig. 11
Touching ceiling
Fig. 12
Screws
Publicité
