Publicité
DRY CONTACT INSTRUCTION
3.4 Remove the male cap from the connector of DRY CONTACT.
3.5 Take out the cable marked DRY CONTACT from the accessory
bag. 3.6 Connect the cable.
3.7 Screw the cable clamp to fasten the cables.
3.8 Reinstall the electric control box cover and front panel.
3.9 Select the Mode and follow the wiring diagram as mentioned on above item 2 to connect
the wirings to end applications.
3.10 Use the remote controller and follow the "Dry contact delay time setting" to set the
customerized time.
9
V.1
Publicité
