Publicité
How To Use Your TUSHY Ace
Before using your TUSHY Ace, make sure it is plugged into a
grounded, 3-prong 120V outlet, there are batteries in the remote
and your water valve is open.
Remote Functions:
SINGLE TAP FUNCTIONS
Pressure,
Temperature,
+ Nozzle Angle
LED Indicator
BUM
Bum Wash
DRY
Bum + Front Dry
Decrease Function
(Angle, Temperature,
Pressure)
Nozzle Angle Control
ANGLE
Seat Temperature
Control
FRONT
Front Wash
Stop
Increase Function
(Angle, Temperature,
Pressure)
SEAT
WATER
Water
TEMP
TEMP
Temperature
Control
30
To operate your TUSHY Ace with the remote, tap the setting button
you want to change (nozzle angle, pressure, or temperature), then
use the increase or decrease buttons to adjust that setting. Next, press
Bum or Front wash to activate the spray. You can also change these
settings during operation to fine tune your preferences.
Once you have completed your wash, tap the Dry button to acti-
vate the bum dryer. Pressing the + and - buttons during drying will
increase or decrease the temperature of the air. Use the Stop button
to stop any function. If you want to warm up your seat before taking
it for a drive, you can adjust the Seat Temperature without activating
the seat sensor. To turn it off, press the stop button. If your remote
lights are flashing red, then your batteries are low and need to be
replaced.
Special functions/modes
Oscillating Power Wash
Double click on the Bum or Front wash buttons
BUM
FRONT
to activate the power wash setting which will
oscillate the nozzle during wash sequence.
Manual Self-Cleaning Function
Press and hold the Seat Temperature and Water
Temperature buttons for 5 seconds to activate
SEAT
WATER
TEMP
TEMP
the self-cleaning function. The Ace automatically
cleans the nozzle after every use, but you can do
it manually too if you're a clean freak!
Soft Reset
Press and hold both the + and - buttons for 5
seconds to reset the TUSHY Ace to factory con-
ditions. Try this if your Ace is acting a little funky.
Mute Function
Want Ace to whisper softly into your rear?
Activate the Mute Function by holding the stop
button for 10 seconds.
• After 5 seconds, you'll notice the lights turning
white—keep holding!
10 Seconds
• These lights will act as a visual countdown for
5 more seconds. Once they turn completely off,
you're muted!
• If you decide you want to hear the beeps
again, just follow the same steps outlined above!
31
Publicité
