Publicité
Product forms
Our product is available in three forms to suit different preferences and needs:
• Custom Assembly Kit: Ideal for those who prefer hands-on approach, this kit includes all
necessary components and assembly instructions.
• Pre-assembled Model on Plate: Offering convenience with partial assembly, this option
allows customization while providing ease of setup.
• Pre-assembled Model in Box: For ultimate convience and quick setup, this fully pre-
assembled model comes enclosed in a box.
Always take into account the safety provisions described in the
manual
Installation
Before installation: Add salt (3.5-4.5 kg/m3) to the water
1) Hang the unit in the desired place
2)Glue the entrance and exit of the cell and the PVC bend, use
enough glue PVC pool glue to prevent leaks. (fig1)
3) Connect to the mains. If necessary, adjust the language of the
device (see below)
4) Connect the probes (left pH – right Chlorine)
Make sure following requirements are met:
Always keep the product in an upright position. If the product is tilted
or placed on its side, the electrodes or flow switch may not be able to
measure correctly. Flow switch, pH and redox electrodes must be
placed vertically in a horizontal pipeline. The flow switch must be
oriented in the direction of the arrow on the switch. The pH and
Redox probes have to be in a horizontal line, at a maximum angle of
45°.If the salt electrolysis is placed horizontally, with water flowing in
the direction of the flow arrow printed into the electrolysis cell casing.
The "top part" of the unit contains safety sensors, which must always
be in contact with electrolyzed water. It is strictly forbidden to mount
the unit counter-current
glue
glue
3
Publicité
