Publicité
CLEANING
Always unplug before carrying out any
cleaning work.
Check your machine periodically before
starting work.
Damaged cutting blades must be
repaired or replaced by a qualified
service technician before operating the
machine.
After each cutting operation, clean the
cutting blade with a soft brush and cloth
with lubricating fluid oil and spray a thin
layer of fluid protective oil.
It is recommended to clean the device
after every use.
Do not use cleaning products or solvents
as this could damage the plastic parts of
the appliance. It is necessary to take into
account that no water enters the interior
of the device. If water enters the electrical
appliance, there will be a greater risk of
electric shock.
Store the machine with the supplied blade
protection cover.
ANOMALIES AND REPAIR
In the event of a breakdown, take the
device to an authorized Technical
Assistance Service or contact Customer
Service on the website
www.casalstools.es.
Do not attempt to disassemble or repair it
as there may be danger. If the network
connection is damaged, it must be
replaced, proceed as in the case of a
breakdown.
CHARACTERISTICS
Maximum absorbed power: 520W
Nominal voltage: 230-240V
Frequency: 50Hz
Cutting capacity: 16 mm
Cutting length: 360 mm
No-load speed: 0-1800/min
Sound pressure level (LpA) = 87.93 dB,
KpA = 3 dB
Sound power level (LwA) = 98.93 dB, KpA
= 3 dB
Guaranteed Lwa: 102 dB(A)
Vibration ah = 4.789 m/s2
Inaccuracy K = 1.5 m/s2
Wear ear protection. Exposure to noise
can be harmful to your hearing.
Do not use the device near flammable
anesthetic mixtures with air, oxygen or
nitrous oxide.
Note: These features are subject to
change without prior notice, depending on
the improvements introduced to the
device.
Note: Due to the manufacturing tolerances
of this product, the maximum absorbed
power may differ from that specified.
Sound level measured according to EN
62841-1 standard
The vibration emission level indicated in
this information sheet has been measured
according to EN 62841-1 and can be used
to make a comparison between tools.
Likewise, valid for an evaluation of the
preliminary exhibition.
The value of vibrations during use of the
power tool may differ from the total
declared value depending on the way the
tool is used.
Safety measures must be identified to
protect the operator based on an
estimate of exposure under actual
conditions of use (taking into account
parts of the operating cycle, shutdown
and idle times, as well as trip time). .
Publicité
