Télécharger Imprimer la page

iTools ITBAS400 Mode D'emploi page 28

Publicité

FREQUENTLY ASKED QUESTIONS / TROUBLESHOOTING
Question/Problem - Cause
Cause
The pump won't turn on:
• The power cord is not plugged in or there is an
electrical fault;
• The switch / float level is lower than the level at
which the pump is applying suction;
The pump turns off suddenly while it's working:
• The heat sensor shut the pump down because it
was overheating;
The pump starts but does not pump any water:
• The pressure hose is bent or clogged;
• Air is blocking water from being taken in;
• The suction base or turbine is clogged;
• The level of liquid is lower than the level at which
the pump is applying suction;
The pump does not turn off:
• The float switch is stuck and is unable to drop
along with the water level;
Not enough water is being transported:
• The suction base or turbine housing is clogged;
• The pump's power is reduced due to the water
being extremely dirty and mixed with abrasive
substances;
The pump automatically shuts off after it has only
been running for a short amount of time:
• The protective feature installed within the motor
shuts it off due to the water being excessively
dirty;
• The temperature of the water is too high so the
engine's internal protection turns it off;
28
Solution
• Check the plug, socket and circuit breaker of the
supply circuit;
• Put the float switch in a higher position;
• Turn the power off and clean the turbine;
Monitor the temperature of the liquid and ensure it
does not go over 35°C;
• Insert the hose correctly and clean it;
• When inserting the pump into water, it should be
tilted slightly to ensure water enters the turbine
chamber. If necessary, tilt the pump backwards and
forwards several times until no more air bubbles
appear.
• Clean the suction base with a water jet;
• Lower the pump;
• Release the float switch so that it is able to maintain
its position on the water level;
• Clean the suction base and turbine housing;
• Clean the pump and any worn parts;
• Remove the plug from the electrical outlet and
clean the pump and well,
• Do not let the temperature of the water exceed
35°C;

Publicité

loading

Produits Connexes pour iTools ITBAS400