Publicité
_cr-kuehlschraenke.book Seite 40 Montag, 27. Februar 2012 12:46 12
Installing and connecting the refrigerator
7.1
Installing the refrigerator
Caution
a
– Fasten the device as described in the operating manual to
prevent hazards.
– Keep objects clear of openings in the housing or mounting
structure (such as ventilation slots).
– The refrigerator is only suitable for installation in a fitted niche.
Once it is installed, only the front of the appliance may be
accessible.
Note
I
In the case of integrated refrigerators, please remove the locking
mechanism at the top and bottom. You can contact the Dometic
WAECO branch in your country for more information (addresses on
the back of the operating manual).
The appliance is designed for ambient temperatures between +18 °C and
+43 °C. In continuous operation, the air humidity may not exceed 90 %.
Set up the fridge in a dry, sheltered place. Avoid placing it near heat sources
such as radiators, gas ovens, hot water pipes etc. Do not let it stand in direct,
strong sunlight.
Install the refrigerator so that the warm air produced can easily flow away
(either upwards or to the sides). Therefore make sure there is adequate
ventilation (fig. 8, page 6).
No. in
fig. 8, page 6
1
2
3
4
The condensation which forms during normal operation of the refrigerator
can be drained off via two outlets on the appliance. For delivery purposes,
these outlets are sealed. The two outlets are located on the rear and on the
underside of the appliance (fig. m, page 12).
40
Explanation
Cold intake air
Hot waste air
Condenser
Spacing above the fridge if insufficient air can circulate above
or at the side.
CR50, CR65, CR80, CR110, CR140
EN
Publicité
