Publicité
All manuals and user guides at all-guides.com
* Important: If a remote control button does not work when pressed, press the
and try the button again.
DF2702-K(P34-37 tape OP).p65
Program End Search
Locates end point of recording for continuity.
1
Press SEARCH twice in Playback or
Stop mode to display PROGRAM
END SEARCH screen .
2
PROGRAM END SEARCH
SEARCH START
EX I T
:
SEARCH
Example of Program End Search operation.
Fig.1
Program 1
Press SEARCH button
Fig.2
Program 1
Press SEARCH button
Fig.3
If search exceeds a few seconds in BLANK area.
Program 1
End Point
Upon locating end point...
The unit searches slightly past end point,
reverse searches, and plays the last few
seconds of the program, then stops.
Press SEARCH button
Note
• If Program End Search is started very close
to an index mark, that mark may be
skipped over.
35
button on the remote
Press FF
to start search.
To cancel,
:
FF
press PLAY or STOP.
PLAYBACK DIRECTION
Program 2 or BLANK
End Point
FF
Program 2
BLANK
BLANK
End Point
FF
Press SEARCH button
Program 2
BLANK
FF
2002/03/08, 18:28
35
Publicité
