Publicité
WARNING! SAFETY INSTRUCTIONS
Please read this manual carefully before plugging in. Follow all instructions and heed all
warnings.
Warning: Please refer to full details in separate
Important Safety Instructions CATS-90009.
Warning: before going any further, make sure
that your amp is compatible with your mains
electricity supply. If you have any doubt, please
seek help from a qualified technician – your
Marshall dealer can help you with this.
MAINS INPUT & FUSE
The specific mains input voltage rating that your
amp has been manufactured for is indicated
on the rear panel of the amp. Never attempt to
bypass the fuse or fit one of the incorrect value
or type.
Warning: your amp must be switched off and
disconnected from the mains electricity supply
before you check and/or change any fuse.
IMPORTANT SET UP INFORMATION
Follow the start-up procedures below to safely
switch on your amp.
Warning: Failure to follow these instructions may
damage your amp.
1. If using your DSL amp with an extension
cabinet, make sure the power handling rating
of the speaker cabinet is equal to or higher
than the output power of the amp. Connect
a single 16Ω speaker cabinet to the speaker
output on the rear panel.
Note: When connecting a speaker cabinet
make sure that you use a proper speaker
cable. Never use a screened (shielded) guitar
cable for this purpose.
2. Ensure the power switch is switched off and
set all master volumes on the front panel to
zero.
3. To use the footswitch, connect the footswitch
tienmanhaudio.vn
cable to the footswitch socket on the rear
panel of the amp.
4. Connect the supplied mains (power) lead into
the mains input on the rear panel first and
then into an electrical outlet.
5. Plug your guitar into the input jack socket on
the front panel.
6. Turn the front panel power switch on. The
switch will glow red. Turn the selected channel
volume up to your preferred level and your
amp is ready to play.
TRANSPORTING YOUR EQUIPMENT
Please ensure that your amp is switched off,
unplugged from the mains electricity supply and
all removable cables have been disconnected from
your equipment before attempting to move it.
Only move the amp on its own; do not attempt to
move it while it is stacked on top of a cabinet or
other equipment.
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed
ENGLISH
2
Publicité
