Publicité
8.0 TROUBLESHOOTING
problem
The tacker does not work
(Note: The tacker only
works when the tacker is
attached and pressure is
applied to the locking
pin).
9.0 TECHNICAL DATA
Item no.
Model
U
P
Protection class
Shots/min
9.1 INFORMATION ON VIBRATION REDUCTION
The indicated vibration emission value complies with EN 60745-2-16. The actual existing vibration
emission value during the use of the machine may differ from the value indicated in the operating
instructions or by the manufacturer. This can be caused by the following influential factors, which
should be taken into account before or during use:
Is the machine used correctly?
•
Is the machine in good working condition?
•
If you notice an unpleasant feeling or skin discoloration on your hands while using the machine,
stop working immediately. Take sufficient breaks from work. Failure to take adequate breaks may
result in hand-arm vibration syndrome.
The degree of stress should be estimated depending on the work or use of the machine and
appropriate breaks should be taken. In this way, the degree of stress can be significantly reduced
during the entire working time. Minimize the risk to which you are exposed in case of vibrations.
Maintenance of this machine must be carried out in accordance with the instructions in the
operating manual. Avoid using the machine at temperatures of t=10°C or less. Make a work plan
which limits the vibration exposure.
9.2 INFORMATION ON NOISE REDUCTION
There is some noise exposure to this machine that cannot be avoided. Reschedule noisy work to
approved and designated times. If necessary, observe rest periods and limit the duration of work
to the minimum necessary. For your personal protection and the protection of nearby persons,
wear suitable hearing protection.
10.0 DISPOSAL
At the end of your item's long service life, please dispose of the valuable raw materials properly
so that proper recycling can take place. If you are not sure how best to proceed, the local waste
disposal companies or recycling centres will be happy to help.
solution
Lock the tacker (lock-on position).
•
Pull out the power plug
•
Open the cartridge holder by pulling the reloading lever and
•
letting the stuck nails/staples fall out.
Reload the tacker.
•
Test the tacker on something to be trashed.
•
102955
DBET001
220-240V~50Hz
45W
II
30
Nails type
Staples type
Lpa
Lwa
Vibration value
16
15 mm
6-14 mm
73.8 +3 dB(A)
84.8 + 3 dB(A)
4.678+1,5 m/s2
www.DEUBAXXL.de
Publicité
