Publicité
EN
Assembly instructions
Assembly of base
1. Attach column to base with 4 screws as shown.
2. Unscrew I take out extension neck.
3. Slide stand ornament down the column to rest on base.
4. Pull out the internal pole and screw I fasten the extension neck back.
CAUTION! Height adjustment ring must be fully fastened before the assembly of the motor section to the stand.
Spinner
Tighten
Loosen
Plastic nut
Fig. 1
Screw
Screw
Fig. 3
Operating Instructions
Remote control and control panel
1 . Speed is controlled by depressing the control keys.
Button (Key) 0: Stop
Button (Key) 1: Lower
Button (Key) 2: Medium
Button (Key) 3: High
2. To make/stop the fan head oscillate. Push down/pull up the clutch knob.
3. The airflow can be adjusted upward or downward by loosening the tilt adjustment knob and
adjusted the vertical angle as desired. Retighten the knob securely.
4. The height of the fan can be adjusted by loosening the height adjustment ring carefully raising
or lowering the fan and firmly tightening the ring.
3
Tighten
Spinner
Slot
Retaining Pin
Blade
Fig. 2
WWW.NIKOLAOUTOOLS.COM
Assembly of blade of grilles
1. Remove the spinner on the head unit by turning it clockwise. Then remove the
plastic nut by turning it counter-clockwise.
2. Place the rear guard to the head unit make sure the handle is upward.
3. Screw on the plastic nut (clockwise) securing the fan guard on the head unit.
4. Discard the small plastic sleeve located on the motor shaft.
5. Install the fan blade onto the motor shaft. Make sure the fan blade slot fits into the
retaining pin of the motor shaft.
6. Attach the spinner to the motor shaft by turning it counter-clockwise to secure the
fan blade.
7. Secure both guards firmly by tightening the fan guard then close easy clips.
LAMP: Press to turn ON/OFF the lamp installed on the switch panel
OSC/SWING: Press to turn ON/OFF its oscillation
TIMER/TIME: Press to set the timer to ON/OFF maximum of 7.5 hours. Every successful
press made will indicate the number of hours (in additional) it stayed ON.
SPEED/ON: Press to power on the fan, every press selects the fan's speed, up to 3 speed
settings.
MODE: Press to select on three different mode settings (Sleep, Natural and Normal).
• Sleep: It automatically turned ON and OFF depending on the speed selection.
• Natural: Changes automatically from High to Low.
• Normal: Manual selection of the speed control.
OFF: Press to turn the fan OFF (all function).
* The buttons/keys on the control panel correspond to the buttons/keys of the remote
control and can be used control the same functions.
* Images and controls may have slight differences and vary from model to model.
Clutch knob
Publicité
