Publicité
Please be sure not to be bended any of suction inlet hose and outlet hose. This can
causes loosing vacuum power or damage of suction motor. Also use exhaust air hose with
40mm diameter hose.
Exhaust air temperature increases significantly and discharge drastically too hot for most
plastic piping. Therefore, metal piping or heat-resistant pipe is recommended for at least
the first five (5) to eight(8) feet (1.5 ~ 2.5 meters) from the air exhaust valve on the
discharge side. In addition, this piping MUST be guarded and marked "DANGER–HOT–
DO NOT TOUCH."
Do not use hoses such as rubber or PVC hose which are not resistant to
chemicals or disinfectants or insufficient flexibility. Only use PVC flexible
spiral hoses with integrated spiral or hoses of equivalent material
3.7
Suction inlet hose connection
• Remove the cover of suction inlet and push-in tubing connector in the inlet hole
• Connect suction inlet hose (Ø40mm spiral hose) at tubing connector and tighten
with teflon insulation tape
3.8
Waste outlet hose connection
Always use spiral hose with Ø20mm
-
interior
Connect hose to the outlet hole with
-
clockwise
Please be tighten with teflon
-
Always be higher position than
-
drainage
For RAIN1CT connect the outlet
-
hose of the device to the entrance
of the amalgam separator and the
outlet hose of the amalgam
separator to the discharged pipe
3.9
Exhaust air hose connection
• Turn left exhaust air outlet hole clamp
• Connect exhaust air outlet hose to the hole (strongly push-in)
• Turn right exhaust air outlet hole clamp for fasten
• Always place end of the outlet hose out of building or window to prevent noisy
CAUTION
25
Publicité
