Publicité
The positioning and electrical and gas installation should always be carried out by an AUTHORISED
TECHNICIAN, observing the standards of each country.
It is advisable to install an extraction hood for the optimum operation of the appliance.
Place the appliance in a well-ventilated place.
Level and adjust the height of the appliance. (Fig. 1)
An AUTHORISED TECHNICIAN should always carry out the appliance's electrical connection.
The legal standards in force in each country on connections to the mains should be taken into account.
Check that the mains voltage corresponds to that indicated on the nameplate.
Use cable sleeves made out of polychloroprene or other similar materials (H05RN-F), for the
connection.
Put an autonomous power switch with fuses into the mains socket, with a minimum distance
between contacts of at least 3 mm.
It is obligatory to earth the appliance. The manufacturer takes no responsibility if this requirement
is not fulfilled.
The section of cable sleeve and the rating of the fuses to be installed in the power switch are indicated in
table nº3.
To access the appliance's electrical connection terminal strip (see Fig. 2), loosen the switchboard cover
screws. Pass the cable sleeve through the stuffing box located in the switchboard and connect it to the
terminal strip.
VERY IMPORTANT: Before putting the switchboard top on, fasten the electric supply cable tightly to the
stuffing box.
When several appliances are installed in series, they should be earthed to each other using the point
assigned for this purpose, located in the rear part of the appliance
The water intake and its location within the appliance are defined in the "General Dimension and
connection" with the letters "AF and AC". The water pressure must be between 2 and 4 bar and the
maximum temperature is 60ºC. The water intake in the machines is 3/4". To fill up the pan turn the water
inlet tap as shows Fig. 4 to the required position
Usage.
When the appliance has been installed, clean the surface of the grill. Use water and detergent, do
not use abrasive products, especially in those with hard chrome plating, and block the fat outlet.
Turning the resistors on and off.
a)
Activate the power switch.
b)
Turn the adjustment thermostat control clockwise until pilot light 2 turns on.
c)
Turn the adjustment thermostat control clockwise to the required position (TABLE 2).
d)
To disconnect, turn the thermostat control anticlockwise to position 1- OFF (•).
1.- INSTALLATION
Positioning and levelling
Electrical connection
Water connection
2.- USE
Turning the appliance on
15
Publicité
