Publicité
•
For additional protection the installation of a residual current device (RDC) with a rated residual
operating current not exceeding 30mA is advisable. Ask an electrician for advice (Argentina/
Chile).
•
While using the appliance, keep your hair away from the air inlets.
•
Do not operate with a voltage converter.
PARTS
1. 1000W power handle
2. Speed/heat selector switch (f, N, O)
3. 50 mm mixed bristle brush
4. Conical curling wand
5. Pre-styling nozzle
INSTRUCTIONS FOR USE
Prepare the hair for styling
•
Wash and condition the hair as normal.
•
Squeeze out excess moisture with a towel and comb through.
•
Using the pre-styling nozzle rough dry the length and roots until 80% dry.
•
Divide the hair into sections, style the lower layers first.
To fit/remove attachments
Fit the attachment before you turn on the appliance.
CAUTION: Attachments can become hot during use, let them cool before removing.
1.
To remove, twist the attachment until the markings line up as shown in figure A and pull it off
the power handle.
2. To fit an attachment, align the symbols on the power handle and attachment as shown in figure
B then twist the attachment until it locks into place.
Speed and temperature settings
1.
Plug your styler in to the mains power supply.
2. Turn your air styler on and select the appropriate setting for your hair by sliding the speed/heat
selector switch.
3. Your air styler has three settings:
•
High heat/speed O: Thick and difficult to style hair.
•
Low heat/speed N: Thin/fine, damaged or bleached hair.
Cool f: Helps to set your style with cool air.
•
4
SAVE THESE INSTRUCTIONS
B
CAUTION: This product is not suitable for
use in bath or shower.
6. Removable inlet grille
7. Hang up loop
8. Swivel cord
9. Styling glove (not shown)
Publicité
