Publicité
The hammer has been designed to perform drilling, boring
and chiseling operations in concrete, brick, stone and
asphalt.
While working with the rotary hammer, you should take into
consideration some cares and procedures of use:
▪ If the drilling/impact accessory jams, switch off the
rotary hammer immediately. Avoid high reaction torques
that cause kickback;
▪ Always work with the auxiliary handle fitted and hold the
hammer with both hands. Loss of control of the rotary
hammer can cause serious injury;
▪ Do not apply too much pressure on the rotary hammer
against the workpiece/object. If the speed drops
abruptly, reduce the pressure on the hammer
immediately;
▪ Never put down the rotary hammer before the drill bit,
pointed or flat chisel, has completely stopped;
▪ Wear
hearing
rotary/demolition hammers. Exposure to noise can cause
hearing loss;
▪ Work in such a way that the power cord is always behind
the hammer during operation;
▪ Switch off the rotary hammer immediately if any of the
following problems occur:
- Sparks in the brushes and smoke appearance;
- Grease leakage through the ventilation slots;
- Damage on the rotary hammer housing;
- Damage to the ON/OFF switch;
- If you sense smoke or a burning smell.
Never change the operating mode while the motor is
running, otherwise unexpected accidents may occur.
Change the operating mode when the motor is completely
stopped.
1. Set the position (
) on the selector switch (9) in the
direction of the arrow (
2. Fit the drill bit into the chuck hole (2);
3. Press the "ON/OFF" switch (6) and touch the drill bit
against the surface to be drilled;
protection
while
);
4. Press the rotary hammer in the direction of the surface
to be drilled. It is not necessary to apply too much
pressure;
5. To switch off the rotary hammer, release the "ON/OFF"
switch.
Never change the operating mode while the motor is
running, otherwise unexpected accidents may occur.
Change the operating mode when the motor is completely
stopped.
1. Set the position ( ) on the selector switch (9) in the
direction of the arrow (
operating
2. Fit the impact accessory into the chuck hole (2);
3. If using a chisel, adjust the position to the required
direction;
4. Press the "ON/OFF" switch (6) and touch the drill bit
against the surface to be drilled/chiselled;
5. Press the hammer in the direction of the surface to be
drilled/chiselled. It is not necessary to apply too much
pressure;
6. To switch off the rotary hammer, release the "ON/OFF"
"switch.
Never use pointed or flat chisels with the rotary
hammer in "Hammer Drilling" mode (
they are used in the "Demolition" position ( ).
This hammer can be used in continuous mode without
pressing the "ON/OFF" switch (6). To do so, press the switch
and then the lock button (10).
To adjust the position of the chisel, set the mode selector
switch (9) as shown in the picture and rotate the chuck (2)
until the chisel is in the desired position. When you turn the
mode selector switch to select the operating mode, the
chisel is locked.
);
). Make sure
Publicité
