Publicité
Description
The wind and rain sensor consists of a wind wheel and a rain sensor
surface. It is used for automatic control of SHEV and venting units.
The wind and rain sensor is equipped with a potential-free change-over
contact with a contact rating of 60 V/2 A.
In the event of wind and/or rain, the change-over contact switches from
normally closed contact to normally open contact.
Test setting, wind trigger threshold, actuation delay, drop-out delay and
actuation in case of power failure are set on a 6-pole DIP switch in the
sensor.
Beaufort table
Wind force
Wind speed
in Beaufort
0
1
2
3
4
5
6
10.8 – 13.8
7
8
17.2 – 20.7
9
20.8 – 24.4
10
24.5 – 28.4
11
28.5 – 32.6
12
2 VELUX
®
Wind speed
in m/s
in km/h
0 – 0.2
< 1
0.3 – 1.5
1 – 5
1.6 – 3.3
6 – 11
3.4 – 5.4
12 – 19
5.5 – 7.9
20 – 28
8 – 10.7
29 – 38
39 – 49
13.9 – 17.1
50 – 61
62 – 74
75 – 88
89 – 102
103 – 117
> 32.6
> 117
Operation/Function
Wind-triggered actuation
The potential-free contact switches when the wind sensor is actuated.
The red LED in the sensor is lit. The wind speed at which the wind
sensor is actuated is settable.
Note: Depending on your settings, the wind sensor will be reset 10 or
20 minutes after the last sensor actuation.
Rain-triggered actuation
The potential-free contact switches when the rain sensor is actuated.
The red LED in the sensor is lit.
Note:
Depending on your settings, the rain sensor will be reset 10 or
20 minutes after the last sensor actuation.
Description
Calm
Light air
Light breeze
Gentle breeze
Leaves and small twigs in constant motion
Moderate breeze
Fresh breeze
Strong breeze
Near gale
Gale
Strong gale
Storm
Violent storm
Hurricane
Severe storm damages and devastation
Specifications
Smoke rises vertically
Direction shown by smoke drift
Wind felt on face
Small branches moved
Small trees in leaf begin to sway
Large branches in motion
Whole trees in motion
Twigs break off trees
Slight damage to houses
Trees uprooted
Considerable storm damage
Publicité
