dirna Bergstrom bycool green line LITE Instructions De Montage page 20

LITE
EN
2
Glue the EPDM seal around the hatch gap (see
the detail for cutting the ends of the seal joint).
HOW TO CUT EPDM GASKET TO AVOID
!
WATER FILTRATION INTO THE CABIN
A- Glue gasket, keeping 100 mm of protection
paper at each side.
B- Remove the two pieces of paper.
C- Glue by pressing both ends.
B
Gasket
3
Position LITE equipment in the hatch gap in the
position indicated.
Gasket
Remove
2
A
Gasket
100 mm Approx. (protection paper)
C
Gasket
3
20
®
15 mm
Gasket
Cabin roof
Gasket