Publicité
OPERATING INSTRUCTIONS
1. Check the heater to be sure it is not damaged.
2. Connect the power cable with Input hole on the heater, and insert the plug
in the socket.
3. Switch on main power switch to start the heater
4. After use, switch off the main power switch. Finally remove the plug from
the socket.
This wall dryer is able to connected with each other by an IEC C7 type
connector cable (which can be found in the package if you buy the dual or
triple packs). Please use 3pcs as maximum if you want to use such connection.
By doing this, one heater need to be connected with the socket by using the
main cord and connect with the power input, this main heater can suppler
power at the power output connector with a C7 type cable connected with a
second heater(for this second heater please connect the C7 cable with power
input connector). The third heater can do same way with heater number 2.
EN
15
Publicité
