Publicité
EN
71mm
DRILLING TEMPLATE
14
INSTALLATION
Unpack your package and find the heater together with the feet and wall
mounting accessories pack.
Free standing installation
1. Take out the two feet from the package.
2. Put the heater into the slot of the feet.
Wall mounting installation
1. Mark the positions of the two holes to be drilled on the wall, and drill the
holes with the drill bit (picture 1). Make sure the distance between each
hole is same as the round holes on the brackets at back of the heater. The
drilling template paper in the package can help you to fix the drill position
easily, which is at the scale of 1:1.)
6mm
2. Insert the plastic rails fitting into the holes (picture 2).
3. Insert the metal screws into the plastic rails (picture 3).
4. Lift the heater and aim the two round holes on the brackets at back of the
heater to the 2 screws on the wall(picture 4), and slide the screw from
Position A to Position B by moving the heater slightly (picture 5).
25mm
366mm
70mm
63mm
6mm
DRILLING TEMPLATE
Publicité
