Publicité
Reset to factory settings
A factory reset is performed by pressing the programming button for 8 seconds. 1 second after the button
has been pressed, the white LED starts fl ashing and indicates the readiness to receive a CV. After 8 sec-
onds the green LED will light up and the factory settings will be restored. The programming button should
now be released within 1 second to avoid switching back to programming mode.
R-BUS status via Z21
If you have connected the Z21
sections to be monitored with one of the 16 occupancy detection terminals, then you can use the con-
fi guration software "Z21
current occupancy status or see which track sections are occupied.
Maintenance Tool
®
- Detector X16 correctly and if you have connected the occupancy detector
®
Maintenance Tool" in the R-BUS tab in the R-BUS status section to verify the
®
23
Publicité
