z21 Detector X16 Manuel D'utilisation page 18

DETECTOR DETECTOR X16
Current sensor
With this method, the feedback devices measure the current that is fl owing through the track section. This
results in each of the current consumers generating an occupied message for this section.
2-conductor track
For the power supply, connect the inputs P and N to the corresponding booster outputs and connect the
16 occupied detector terminals to the corresponding occupied detector sections.
NOTE: The occupied detector sections are to be separated from the system from both sides.
Please also ensure that the separation consistently takes place on the correct voltage side. Short
circuiting could otherwise occur when the separation points are crossed.
18 18