Télécharger Imprimer la page

Nexxt CO081223 Mode D'emploi page 9

Publicité

Power Supply
This product uses 220V AC power supply. Please check whether the voltage (volts)
marked on the nameplate fully conforms to the facilities in your home.
Please make sure to turn off the vacuum cleaner and unplug the power plug after
use, before replacing accessories and cleaning and maintenance.
If the power cord is broken, it must be replaced by special personnel of the manufac-
turer, its maintenance department, or similar departments to avoid danger.
Please hold the power plug to plug and unplug the power cord and keep your hands
dry. Do not pull, twist, or twist the power cord.
When the product is not used for a long time, please turn off the power switch and
unplug the power plug.
Ultraviolet Rays
This product is equipped with an ultraviolet sterilization lamp. Please avoid looking
at the bottom of the machine when the power is connected to prevent the injury
caused by ultraviolet radiation to the human body.
Do not irradiate animals and plants with ultraviolet lights to avoid damaging them.
Do not focus the ultraviolet lamp on one place for continuous irradiation, which is
easy to cause damage to the cleaning object.
Safety Advice
Do not jam the power cord or let it pass through sharp edges and corners.
If you use an extension cable, make sure it is in good condition and with your mite
vacuum cleaner.
Do not move the mite removal vacuum cleaner by pulling the wire. Use the transport
handle to move the mite removal vacuum cleaner. Do not use the power cord to lift
the mite removal vacuum cleaner.
Please never cut off the power supply of the mite removal vacuum cleaner by pulling
the power cord.
Make sure that the dust cup assembly has been installed into the machine and a
good filter screen is installed.
Make sure the power switch is off.
Please shut down and cut off the power supply of mite removal vacuum cleaner after
each use.
Before maintenance and cleaning, be sure to stop the machine and cut off the power
supply of the mite removal vacuum cleaner.
Repairs must be carried out by professionals using original parts. Repair by the user
may be dangerous and the warranty will be cancelled.
This product meets the relevant standards in the electromagnetic field (EMF).
According to the current scientific proof, this product is safe if used correctly and
operated according to the instructions in this user manual.
Maintenance and service
The dust cup shall be cleaned in time to avoid vacuum cleaner failure.
The vacuum cleaner can be wiped with a wet cloth containing water or neutral water
dip. Gasoline, alcohol, banana water or oil are not allowed. Otherwise, the shell
will crack or fade.
07
EN

Publicité

loading