Idmed ToFscan Manuel Technique page 22

Proximity fields
from RF
wireless com-
61000-4-3
munications
equipment
Electrical fast
transients /
61000-4-4
bursts
Surges
Line-to-line 61000-4-5
Surges
Line-to-ground 61000-4-5
Conducted
disturbances
induced by RF 61000-4-6
fields
RATED power
frequency
61000-4-8
magnetic fields
Voltage dips
61000-4-11
Voltage
interruptions 61000-4-11
Stimulations
• TOF (Train Of Four), calcul du T4/T1 et du T4/Tref.
• TOF Auto (TOF programmé de 15s à 15min).
• TET (Tétanos 50 Hz)
• DBS (Double Burst Stimulation) mode 3.3 et 3.2.
• PTC (Post Tetanic Count)
• ATP (Mode automatique TOF et PTC)
• TWITCH (Single Twitch) 0.1 Hz et 1 Hz.
Capteur d'accélération
• Accéléromètre tridimensionnel (+/- 8 G sur 10 bits, Fq: 200 Hz, Résolution 0.016G)
Manuel Technique ToFscan - Rev G
Complies to
IEC table 9 of IEC
60601-1-2
(2014)
± 2 kV
IEC 100 kHz
repetition
frequency
IEC
± 0,5 kV, ± 1 kV
± 0,5 kV, ±
IEC
1 kV,
± 2 kV
3 V
0,15 MHz –
80 MHz
6 V in ISM
IEC bands
between 0,15
MHz and
80 MHz
80 % AM at
1 kHz
IEC 30 A/m
50 Hz or 60 Hz
0 % UT;
0,5 cycle
At 0°, 45°, 90°,
135°, 180°, 225°,
270° and 315°
IEC
0 % UT;
1 cycle and
70 % UT; 25/30
cycles
Single phase:
at 0°
IEC
Complies to In order to prevent electromagnetic
table 9 of IEC disturbance, keep minimum separa-
60601-1-2 tion from RF communication equip-
(2014) ment of 30cm
The ToFscan may temporarily not
± 2 kV
display
100 kHz electromagnetic disturbances such
repetition as the use of electrosurgery device.
frequency In that case, the ToFscan will maintain
the safety of the patient and the user.
Mains power quality should be that of
± 0,5 kV, ± 1 kV a typical residential, commercial or
hospital environment.
Mains power quality should be that of
± 0,5 kV, ± 1
a typical residential, commercial or
kV, ± 2 kV
hospital environment.
3 V
0,15 MHz –
80 MHz
6 V in ISM In order to prevent electromagnetic
bands disturbance, keep minimum separa-
between 0,15 tion from RF communication equip-
MHz and ment of 30cm
80 MHz
80 % AM at
1 kHz
Mains power quality should be that of
30 A/m
a typical residential, commercial or
50 Hz or 60 Hz
hospital environment
0 % UT;
0,5 cycle
At 0°, 45°, 90°,
135°, 180°, 225°,
270° and 315°
Mains power quality should be that of
a typical residential, commercial or
0 % UT;
hospital environment.
1 cycle and
70 % UT; 25/30
cycles
Single phase:
at 0°
Mains power quality should be that of
a typical residential, commercial or
hospital environment.
result during transient
22