Publicité
• OPERATION
−
The kettle starts working after pressing button (7) – boiling to 100°C – selecting one of the
preset programs (10) or setting the temperature using buttons (9).
−
The operation of the appliance can be stopped at any time by switching it off with
the by pressing the button (7).
Preset programmes
−
The 100°C temperature is available after pressing button (7).
−
The temperatures: 40°C, 70°C, 80°C, and 90°C are available after selecting the corresponding
button (10).
−
The operation of the appliance is indicated by the illumination of the indicator light of the
selected programme.
−
The jug switches off automatically when the water boils.
−
Operation of the appliance can be interrupted at any time by switching it off using the
button (7).
Manual temperature selection
−
To select the desired water temperature from 40°C - 95°C (in 5°C steps), press the buttons
(9) until the desired value appears on the display (11).
−
After a while, the display (11) will show the current water temperature in the kettle and
heating will start.
−
The operation of the appliance is indicated by the illumination of the controls (7, 8, 10).
The display (11) will show the current temperature.
−
When the set temperature is reached, the kettle will switch off.
−
The operation of the appliance can be stopped at any time by switching it off by pressing
the button (7).
Keep warm function
−
The keep warm function is available for each selected temperature.
−
To activate the keep warm function, select a temperature and then press button (8).
−
Activation of the function will be indicated by the blinking indicator (8).
−
After heating the water to the set temperature, the kettle will monitor the temperature
for 2 hours - when the water temperature drops below the set value by about 5°C, heating
will resume.
−
Pressing the button (8) without first selecting the temperature will only result
in the indicator light (8) flickering for about 3 seconds.
Note: Removing the kettle from the base erases the settings.
• FILTER
The filter does not remove the scale, but it prevents any deposits from getting inside the kettle
while the water is being poured in. The filter should be cleaned regularly. Hard water may block
the filter after boiling water a couple of times.
• CLEANING AND MAINTENANCE
−
Allow the unit to cool down completely before cleaning.
−
Do not immerse the kettle in water while washing up.
−
The outside of the kettle may be wiped over with a damp cloth and washing-up liquid.
−
Water stains inside the kettle can be removed by rubbing with a cloth moisten with white
vinegar; rinse the inside with water afterwards.
o
Limescale should be removed in the following way:
o
Fill the kettle with 0.75 litre of water and bring it to boil.
o
Switch the kettle off and disconnect the kettle from the power supply.
o
Pour 0.1l of vinegar into a jug and leave the solution for a few hours.
o
Discard the solution and rinse the inside with water.
o
Fill the kettle with 1 litre of water and bring to boil.
o
Discard the water and rinse the inside with water.
−
Failure to descale the heating element results in accelerated wear of the kettle's heating
component.
−
Damage resulting from the use of overly aggressive descaling agents available on the
market is not covered by the kettle manufacturer's warranty.
11
Publicité
