Publicité
OPERATING INSTRUCTION
EN
INSTRUCTION MANUAL
CORDLESS KETTLE WITH TEMPERATURE CONTROL PANEL C505
CORDLESS KETTLE WITH TEMPERATURE CONTROL PANEL C505
• GENERAL DESCRIPTION
1.
Spout
2.
Lid + mesh filter
3.
Button to open the lid
4.
Handle
5.
Tank
6.
Base
7.
On/off switch
8.
Function key
9.
Indicator light
– operation
10. Indicator light
– keep warm function
11. Display
12. Water level indicator
• TECHNICAL DATA
−
power: 900-1100W
−
mains voltage:
220-240V~ 50/60Hz
−
capacity: 1.0 l
•
INTENDED USE
The C505 wireless kettle is intended for boiling water. It is fitted with the function of temperature
control and hold. The capacity of the kettle allows to boil 0.5–1.0 l of water.
level is indicated on the indicator (12) and the minimum is inside the tank
• USE
NOTES. Before using the jug for the first time, boil the water 2-3 times and pour out.
−
All setting changes are confirmed by a beep.
−
Place the base of the appliance (6) on a flat, stable and dry surface. There is space in the base
for the excess cable. It is important that the cable is routed out of the base (6) through the
special groove so that the unit stands firmly.
−
Before inserting the plug into the socket, make sure that the data on the unit's rating plate
corresponds to the mains parameters.
−
The appliance should be filled when the lid (2) is opened. The lid is opened using the button
(3). Close the lid by pressing lightly until it audibly snaps shut.
−
Do not fill the kettle when standing on the base.
−
After placing the kettle on the base connected to the power supply, the display (11) will be
illuminated. If no operation is performed within 1 minute, the kettle will automatically enter
standby mode.
−
To start operation, press the button (7).
−
The operation of the device is indicated by the illumination of the indicator light (9).
−
Once the water has been heated to the set temperature, the illuminated indicators turn off
after approximately 30 seconds.
10
2
1
12
11
10
9
8
7
3
4
5
6
The maximum water
(5).
Publicité
