Publicité
• Check that the movable bulkhead is closed (graduated
knob (6) in position "0").
• Carefully clean the part of the blade to be sharpened.
• Reinsert the plug.
• Loosen the locking knob (23) of the sharpener group
(10).
• Raise the sharpener group (10), turning it by 180° so
that both wheels are in working position. See Fig. 1.
• Lower the sharpener group (10) until it locks.
• Secure the group by turning the locking knob (23). See
Fig. 2.
• Switch on.
• Press button (26) and let the blade turn for about 1
minute. When the blade is still, check to see if any burr
has formed on the edge.
• After having verified the presence of burr, switch (5) on
and gently press button (27) for about 3 seconds to
remove the burr produced during sharpening. Put the
graduated knob (6) back to "0" position.
• After sharpening, move the sharpener group (10) back
to its original position, see Fig. 3 and clean the edge of
the blade and the wheels by alcohol.
• After several sharpening operations, remove any
residue from the sharpening wheel with alcohol and a
brush.
BLADE REPLACING
The blade has to be replaced when it is no more possible
to sharpen it or when the distance between the cutting
Publicité
