Publicité
www.costway.com
h)The surfaces are liable to get hot during use.
i)Appliances are not intended to be operated by means of an external timer or separate
remote-control system.
j)When the appliance is not in use and before cleaning, unplug the appliance from the
outlet.
k)WARNING: If the surface is cracked, switch off the appliance to avoid the possibility of
electric shock.
l)The outer surface may get hot when the appliance is operating and first time use, there is
a little smoke and smell, that is normal.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
15.SAFETY IN OPERATION
a)DO NOT OPERATE this hot plate near water sources or flammable liquids.
b)DO NOT OPERATE this hot plate on or near any hot surface. (Hot plate, electric stoves
etc).
c)Always operate this from an earthed domestic 220V-240～50/60Hz power socket.
d)Ensure the hot place is placed on a stable, secure surface to eliminate the possibility of
tipping over or avoid any water in the appliance.
e)Never try to touch the hot surface of this hot plate before it is cooled down.
PREPARATION BEFORE USE
1.Clean the hot plate with a soft damp cloth. Place your hot plate on the level and stable
surface near the electrical socket.
2.Check that the voltage marked on the product corresponds with your supply voltage.
Ensure the controller is in the "OFF" position before plugging in.
3.Always use flat bottom saucepans or containers that make close contact with the heating
element. Ideally, the saucepans or containers should be 180～200mm in diameter. Keep
the surface of the heating element clean and dry.
4. Close supervision is extremely necessary when this hot plate is used by or near children
or invalids. Never operate this hot plate unattended.
OPERATION
1.Put water and/or food in the container (The total amount of water and /or food should
not exceed 80% of the container to avoid overflowing), put a lid on the container and place
it on the hot plate. If there is smoke for the first use, that is normal. To make the unit heat
without any pot about 10 Minutes before cooking.
2.Connecting to the power supply socket. Turn the switch from "OFF" TO "MAX"
position and the indicator light is on for working, the hot plate is in a state of heating.
3.Two points to be reminded by the user when using the new hot plate:
11
Publicité
