Publicité
en-us Installation instructions
5 Installation instructions
Installation instructions
Installation instructions
Observe this information when installing the appliance.
WARNING
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
▶
ON accidentally.
5.1 Kitchen cabinet types
Identify your type of kitchen cabinet before you start
installation.
Check the bottom of the kitchen cabinet where you want to
install your hood.
Framed cabinet
Frameless cabinet
5.2 Preparing the hood location
Use the proper diagram for placement of ductwork and
1.
electrical cutout in the cabinet or wall.
→ "Installation dimensions", Page 10
Install part-way four (4) round head no. 8 x ⅝" mounting
2.
screws into shims or cabinet, according to the proper
diagram.
10
The mounting screws are included in the parts bag, but
wood shims and shim mounting screws are not
included.
Installation dimensions
Refer to the measurements given below for your
installation situation.
8" Round vertical ducting
℄
Center line
A
Hood mounting screws (4)
B
¡ 30" hoods: 12⅞" (327 mm)
¡ 36" hoods: 15⅞" (404 mm)
C
Cabinet front
D
Cabinet bottom
E
Wood shims (framed cabinet bottoms only)
F
8" round duct access hole
G
4¹¹⁄₁₆" (119 mm)
H
8" diameter hole
I
7³⁄₁₆" (183 mm)
J
1⅜" (35 mm)
K
Electrical access hole (in cabinet bottom)
L
1½" (38 mm)
M
10¹⁵⁄₁₆" (278 mm)
5.3 Installing the hood
Run the house power cable between the service panel
1.
and the hood location. Run the house power cable into
the hood through the strain relief previously installed.
→ "Preparing the appliance", Page 9
Publicité
