Publicité
GB
owner'smanual
decrease its functionality. The same applies for the case of heavy dirt or damage. All mechanical
parts of the bike are subject to wear and are exposed to a significant stress.
RIMS
Prior to the ride, check whether the wheels of the pedal-free bike are correctly centred and the
rims are not damaged.
Grooves and cracks can occur on the rim as a result of the use. Riding with a damaged rim is
dangerous – replace the damaged rim!
TYRES
Be sure that the tyres are neither underinflated or overinflated. Meet the values of recommended
tyre pressure which are shown on the side-walls of any tyre. Conversion of pressure units shown on
tyres: 100kPa = 14.22 P.S.I. = 1 bar = 1 at
BRAKE SYSTEM
Brake system consists of brake levers, cables, front calliper, brake shoes, and is one of the most
important components of balance bike. Right brake lever operates rear brake. Brake is set by
manufacturer. For your own safety do not make any brake system adjustments until it is really
necessary! Check periodically the wear of friction surfaces, brake pads and keep rims clean.
Untuned brake system has to be adjusted again or ask a special bike service for help.
BRAKE CABLES
Brake system of balance bike will be effective only when brake cables are correctly stretched. Brake
cables can be set by adjusting screws on brake levers. Lubricate brake cables and outer casings with
oil which provides cables running smoothly. End cup should be placed on cable end to prevent its
ply apart and damage. Damaged or worn out cable must be replaced by new one.
BRAKE ADJUSTMENT
Brake shoes should be 1 mm from the rim in V-type brakes.
WARNING
Brake shoes may not touch the tire - otherwise this could cause an over-heating of the tire!
Check the wear, and if it is necessary, change them. Replace worn out brake shoes with new
one original brake shoes matching your brake type. Brakes should to be adjusted according
to kid´s age and style of riding.
1. Release the safety nut of the adjustment screw on the brake lever. If it is necessary to bring the
pads closer to the rim, turn the adjustment screw counter clockwise out from the thread. Secure
the safety nut.
2. If the cable is too loose, turn the adjustment screw on the brake lever clockwise - into the thread.
4
Now release the screw that secures the cable on the brake arm. Stretch the cable, so that brake
pads are aligned with the rim. Firmly tighten the screw and check the brakes.
IMPORTANT WARNING
Pay attention when braking on wet surface - braking distance of balance bike is longer!
Prior to each ride check, if the braking system of your balance bike is in a perfect condition.
FRAME AND FRONT WHEEL FORK
Make regular checks of frame and wheel fork for any damage. Damages to the frame or wheel fork
(bending or cracks in tubes and weld joints) mainly occur as a result of crashes. Do not keep using
damaged frame or wheel fork, you may get seriously injured.
INTEGRATED PLATFORM FOR FEET
The product KELLYS KIRU RACE provides mobility to the child. It is equipped with the integrated foot
platform. With protruded legs, the child cannot brake. As a result, the balance may be lost and the
child can be ejected, injured or can injure others. In adverse case, the risk of injury results from the
KELLYS KIRU RACE
Publicité
