Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• CONTROL PANEL

1) Timer
o 24-hour timer setup: press this key to set the on/off time of the dehumidifier. The
setting range is 1 to24 hours. Every press adjusts the timer by one hour. To cancel the
timer setup, press twice continuously after confirming the setting time.
2) Dry key
o Press this key to start the INSIDE DRYING procedure in the dehumidifier. This can pre-
vent mould forming inside the dehumidifier due to damp. The whole drying procedure
takes approximately 1 hour. Press this key again to cancel the drying function in the
dehumidifier and return to normal operation before starting to dry.
3) Air speed
o In AUTO or CONTINUOUS mode, the fan speed can be set to HIGH or LOW by turning
the knob.
4) LCD Display
o In AUTO, CONTINUOUS and INSIDE DRYING mode, etc., this figure displays room hu-
midity. When it is set to AUTO mode, this figure shows the set humidity and displays
the set time when in timer mode, and % shows percentage of humidity.
5) Humidity setting
o If this key is pressed, the humidity is displayed in a circle in the range of 30% - 35% -
40% - 45% - 50% - 55% - 60% - 65% - 70% - 75% - 80%. The humidity setting is only valid
in AUTO mode.
6) Mode
o During start-up or timer start-up, press this key to select AUTO, CONTINUOUS and IN-
SIDE DRYING modes, etc.. The indicator lamp corresponding to the selected mode will
light up. Press and hold the Mode button for 3 seconds to activate the Child Lock. Re-
peat the process to turn the Child Lock off.
7) On/off key
o Press this key to turn on or turn off the dehumidifier.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instructions for use
51

Publicité

Table des Matières
loading

Table des Matières