Publicité
Follow the steps below:
1. Start at the lowest stimulation level: press and hold the Vibration or Stimulation
Button continuously (further referred to as the [S] button).
2. If your pet shows no reaction, repeat the first step several times before moving up
to a higher stimulation level.
3. Your pet should not bark or panic when receiving stimulation. If this happens, the
stimulation level is too high and you need to go back to the previous level and
repeat the process.
4. Move up through the available stimulation levels until your pet responds.
5. If your pet continues to show no response at the highest stimulation level, check if
the collar is fitted properly. If your pet has long or thick fur, try using the longer set
of contact points. Then go back to step 1 and repeat the process. If there is no
change, you might need to trim your dog's hair around the contact points.
HOW TO PAIR REMOTE WITH THE COLLAR?
1. On the remote, use the
2. With the remote turned on and the collar turned off, press and hold the ON/OFF
button on the collar for 4-5 seconds.
3. The LED alternately flashes the red and green lights,
indicating that it is ready to pair.
4. Press and hold the tone and vibrating buttons at the
same time, then you will hear 3 beeps, indicating
successful pairing.
HOW TO PAIR THE SECOND COLLAR WITH THE REMOTE?
On the remote, use the
steps (2-4) to complete the pairing process.
TROUBLESHOOTING GUIDE
My pet doesn't react to stimulation
Make sure the Collar is turned on. Check if the battery level is low on either the
Collar or the Remote.
The range of the remote may be affected by a number of factors like terrain,
weather, vegetation, transmission from other radio devices and so on.
channel switch to select Dog 1.
channel switch to select Dog 2. Next, follow the above
+
9
Publicité
