Publicité
These instructions are part of the Duravit
product and must be read carefully and kept
available at all times.
Target readership and qualifications
The product may only be installed by a
qualified plumber.
Explanation of the key words and symbols
NOTICE
Addresses practices not related to
physical injury.
Link to the mounting instructions
in this section
Prompt for inspection
(e.g. for scratches)
Prompt to wear
gloves
Technical data
Operating pressure
Recommended
Test pressure
1 MPa = 10 bar = 145 PSI
Hot water temperature
Safety instructions
Cut and crushing injuries
> Wear gloves when installing the product.
Product and/or property damage
> Observe the local installation regulations
> Equalise pressure differences between cold
> Observe the manufacturer's instructions for
Mounting instructions
Tap unit malfunction due to dirty pipes
> Flush the pipes according to the applicable
Water damage
> Enclose pipes with silicone that does not
max. 1.0 MPa
0.3 - 0.5 MPa
1.6 MPa
> Check the function of the integrated
max. 60 °C
and any country-specific standards at all
times.
and hot water connections.
installation with continuous flow heaters.
1
Flushing and siliconising (diagram 01)
NOTICE
standards before mounting the tap unit.
contain acetic acid.
A1
Maintenance (diagram A1)
non-return valve regularly according to
DIN EN 1717.
5
MAL_57578/24.01.3
Publicité
