Publicité
OPERATION
WARNING!
•
Make sure the pool vacuum is off.
•
Do not use the pool vacuum if any damage is detected.
•
Oil stain could occur due to possible leakage of lubricants applied
to the O-ring.
•
Make sure the pool vacuum is fully immersed in the pool before
initiating operation. The minimum water level required to operate
the pool vacuum must reach above the power ON/OFF switch of
the pool vacuum when it is held in a vertical position. Operating
the pool vacuum when it is not immersed correctly could damage
the unit and void the warranty.
•
DO NOT use the pool vacuum without an intact filter cone in place.
Using your pool vacuum without an intact filter cone in place will
VOID your warranty.
•
DO NOT cover the side slot of the vacuum during operation. The
impeller / motor may be damaged as a result.
•
DO NOT leave the pool vacuum in the water when it is not in use.
•
Ensure the charging base is detached before the pool vacuum is
deployed.
1) Bring your pool vacuum to the side of your pool / spa. Immerse the pool vacuum in water and turn
the power ON/OFF switch to the ON position to initiate operation.
CAUTION! Make sure the pool vacuum is always facing downwards when it is placed into the pool.
Otherwise it may bend the pole connector and damage it during the process.
2) To remove the pool vacuum from the pool, lift the pool vacuum while pointing it downwards in
order to allow water to escape from the outlet valve. Water is going to escape via the handle / pole
connector and draining holes inside the handle chamber on the rear body.
CAUTION! Make sure the pool vacuum is always facing downwards when it is removed from the
pool. Otherwise, the pole connector may be bent and damage the pool vacuum in the process.
3) Rinse the pool vacuum with fresh water after every use. DO NOT use any detergent.
7
Publicité
